大直径TA2卷焊坯制备工艺

此文介绍尺寸为φ1547×L900×δ30的大直径TA2卷焊坯的制备工艺。主要包括卷焊坯设计、展开下料的计算、卷圆工艺、焊接工艺等,可供同类材质圆筒件卷圆时参考。     

重型柴油车实际道路排放与行驶工况的相关性研究

采用SEMTECH-D车载排放测试仪测量了东风柴油卡车在城市实际道路工况以及等速和加速工况下的油耗及污染物排放状况.测试结果显示,测试卡车实际道路综合百公里油耗为17.8 L,NOx、CO和HC排放因子分别为3.96、8.86和2.15g·km-1.其中主干道路况相对较差,油耗与排放因子较高,是所有测试道路平均水平的1.3～1.8倍左右.研究结果表明,重型车油耗及污染物排放与各行驶工况下的速度、加速度均密切相关,车辆在高速加速行驶状态下易产生高排放.车辆在30～50 km·h-1速度区间内等速行驶时,油耗与排放因子最为经济且环境友好.车辆在加速行驶时,油耗与NOx、CO排放因子可达到城市实际道路平均水平的2.0、2.2、1.4倍,急加速时达到2.8、2.1、14倍.应用比功率概念可准确描述车辆在各运行工况下的排放水平,但在重型车上缺乏实验依据,有待进一步研究.     

环境影响综合评价灰色层次模型研究

针对水电工程环境影响综合评价问题，应用拓展的灰关联理论和最小二乘准则，建立了环境影响综合评价的灰色层次模型。以东江水电工程环境影响综合评价为实例说明了该模型的合理性、可信性。结果表明：此基工程使环境总体向理想的１８．１％     

爆炸冲击波作用下靶板的塑性大变形响应研究

对四边约束方形靶板 ,在爆炸冲击波作用下的塑性大变形响应情况 ,进行了理论分析与试验研究。运用能量守恒的方法 ,同时考虑试验过程中靶板的边界约束条件 ,得到了四边约束方形靶板在爆炸冲击波作用下发生塑性大变形时挠度的半经验公式。理论计算与试验结果吻合性较好 ,这种方法可应用于板结构在爆炸冲击波作用下的毁伤或防护方面的工程预测     

The potential of vehicle and road infrastructure interventions in fatal bicyclist accidents on Swedish roads—What can in-depth studies tell us?

Abstract

Objective: The objective of this article is to describe the characteristics of fatal crashes with bicyclists on Swedish roads in rural and urban areas and to investigate the potential of bicycle helmets and different vehicle and road infrastructure interventions to prevent them. The study has a comprehensive approach to provide road authorities and vehicle manufacturers with recommendations for future priorities.

Methods: The Swedish Transport Administration’s (STA) in-depth database of fatal crashes was used for case-by-case analysis of fatal cycling accidents (2006–2016) on rural (n?=?82) and urban (n?=?102) roads. The database consists of information from the police, medical journals, autopsy reports, accident analyses performed by STA, and witness statements. The potential of helmet use and various vehicle and road infrastructure safety interventions was determined retrospectively for each case by analyzing the chain of events leading to the fatality. The potential of vehicle safety countermeasures was analyzed based on prognoses on their implementation rates in the Swedish vehicle fleet.

Results: The most common accident scenario on rural roads was that the bicyclist was struck while cycling along the side of the road. On urban roads, the majority of accidents occurred in intersections. Most accidents involved a passenger car, but heavy trucks were also common, especially in urban areas. Most accidents occurred in daylight conditions (73%). Almost half (46%) of nonhelmeted bicyclists would have survived with a helmet. It was assessed that nearly 60% of the fatal accidents could be addressed by advanced vehicle safety technologies, especially autonomous emergency braking with the ability to detect bicyclists. With regard to interventions in the road infrastructure, separated paths for bicyclists and bicycle crossings with speed calming measures were found to have the greatest safety potential. Results indicated that 91% of fatally injured bicyclists could potentially be saved with known techniques. However, it will take a long time for such technologies to be widespread.

Conclusions: The majority of fatally injured bicyclists studied could potentially be saved with known techniques. A speedy implementation of important vehicle safety systems is recommended. A fast introduction of effective interventions in the road infrastructure is also necessary, preferably with a plan for prioritization.     

Suicide by crashing into a heavy vehicle: Focus on professional drivers using in-depth crash data

Objective: Road traffic suicides typically involve a passenger car driver crashing his or her vehicle into a heavy vehicle, because death is almost certain due to the large mass difference between these vehicles. For the same reason, heavy-vehicle drivers typically suffer minor injuries, if any, and have thus received little attention in the research literature. In this study, we focused on heavy-vehicle drivers who were involved as the second party in road suicides in Finland.

Methods: We analyzed 138 road suicides (2011–2016) involving a passenger car crashing into a heavy vehicle. We used in-depth road crash investigation data from the Finnish Crash Data Institute.

Results: The results showed that all but 2 crashes were head-on collisions. Almost 30% of truck drivers were injured, but only a few suffered serious injuries. More than a quarter reported sick leave following their crash. Injury insurance compensation to heavy-vehicle drivers was just above €9,000 on average. Material damage to heavy vehicles was significant, with average insurance compensation paid being €70,500. Three out of 4 truck drivers reported that drivers committing suicide acted abruptly and left them little opportunity for preventive action.

Conclusions: Suicides by crashing into heavy vehicles can have an impact on drivers’ well-being; however, it is difficult to see how heavy-vehicle drivers could avoid a suicide attempt involving their vehicle.     

Before the crash: A systematic analysis of police narratives to determine the prevalence of pre-crash factors in fatality road transport crashes

Abstract

Objectives: The objectives of this study were to identify the prevalence of pre-crash factors that were present in fatal road transport crashes for the deceased and counterpart road user.

Methods: The study is a retrospective population-based case series study of transport-related deaths reported to coroners in Australia from 2013 to 2016. Data was extracted from the National Coronial Information System.

Results: In total, 6,137 fatality crashes occurred during the study period. Police reports were available for 5,523 crashes (89.9%). The most frequently reported pre-crash factors reported behaviour specifically drivers (e.g., driving without a license or while license was disqualified). Presence of intoxicating substances were also reported in the deceased and counterparts. Analyses of toxicology reports are continuing to determine if rates are comparable to level of use in community.

Conclusions: Coronial report provide detailed information that may be pertinent to understanding and potentially preventing crashes. Also emerging from the data is the extent of pre-crash factors that relate to illegal or deviant behavior and whether these are contextual or contributory factors.     

重庆市内环货车错时限行对空气质量的影响

在分析货车实施错时限行后内环车流量时段分布变化基础上,通过对PM_(2.5)、NO_2等指标的ADMS模型模拟和实际监测数据对比分析,探讨了内环货车错时限行对环境空气质量的影响。结果表明,货车错时限行后主城区环境空气中PM_(2.5)、NO_2小时平均质量浓度分别降低了9.4%和6.0%,峰值浓度明显降低,晚上出现峰值时间往后推移了2~3 h。经ADMS模型模拟计算,内环高峰时段机动车排放对主城区NO_2、PM、VOCs的浓度贡献分别降低了54.1%、56.3%、17.5%,CO浓度贡献不大。内环货车错时限行措施对重庆市主城区空气质量的改善有一定的积极作用。     

辽宁省大型底栖无脊椎动物耐污值及水质评价

根据采自辽宁省河流、水库、湖泊及河口湿地水体的209个大型底栖无脊椎动物样本,以及文献记载数据,依据其系统发育、亲缘关系和相同栖息地环境等进行推算,确定了辽宁省大型底栖无脊椎动物耐污值332个。利用上述耐污值并结合BI指数法对辽河、浑河、太子河流域内20个采样点所获得的大型底栖无脊椎动物监测数据进行分析与评价,结果显示各河流上游段水质良好,中下游河段水质较差。